Pioneer Car 4-Channel Power Amplifier with 600 Watts Maximum Power - GM6300F

The 4-channel GM-6300F delivers a whopping 600 watts max (60 watts x 4 or 150 watts x 2 at 4 ohms; 75 watts x 4 at 2 ohms) — plenty of juice to power your high-quality speakers. It's also got built-in 4-channel crossovers. Speaker level inputs for easy connection to an OEM headunit. Oversized power terminals. And a wide input level of 400mV to 6.5V. Higher Power Having more power isnt just about LOUD. Its also about CLEAN, getting the most out of your speakers and your music. Constant road noise makes it hard for the music to be heard clearly. But with 600 watts max. power, youll get to hear all the words and all the notes. 4-Channel Crossovers For getting the music just the way you like it, 4-channel crossovers are tough to beat. You can route the low frequency signals (80Hz or lower, -12dB/octave) to the speakers that handle them best, and filter out the higher-frequency signals. This optimizes your systems efficiency and delivers the best possible sound quality. Speaker Level Inputs What, you DONT own a Pioneer headunit? Well, we wont hold it against you. In fact well even help you build onto your system. The GM-6300Fs speaker level inputs allow you to connect your OEM unit (or any unit that doesnt have the typical RCA-type inputs) without having to buy add-on adapters. SO, the install goes faster, you save money, and youve got a Pioneer amp in your vehicle. CEA 2006 Specifications Output Power (4 Ohm, <=1% THD): 60 Watts x 4 Output Power (4 Ohm Bridged, <=1% THD): 150 Watts x 2 Output Power (2 Ohm, <=1% THD): 75 Watts x 4 Signal to Noise (1 Watt into 4 Ohms):  80 dBA Dynamic Power (4 Ohm):  60 Watts Specifications Peak Music Power: 600 Watts Number of Channels: 4 Load Impedance Capability:  2~8 Ohm (Stereo); 4~8 Ohm (Bridged) Continuous Power (4 ohm):  60W x 4 Continuous Power (2 ohm):  75W x 4 Continuous Power Bridged (4 ohm):  150W x 2 Frequency Response:  10Hz ~ 50kHz Total Harmonic Distortion:  0.010% Signal-to-Noise Ratio:  >95dB Features Bridgeable Channel # Capability: 4/3/2 PWM Regulated MOSFET Power Supply Screw-Type Speaker Terminals Balanced Isolator Input Circuit RCA Inputs: 4 Channel RCA Outputs (Pass Thru) Speaker Level Input: 4 Channel Input Level Control:  Hi-Volt (400mV ~ 6.5v) Built-in Crossover: LPF/HPF (Front/Rear Independent) Crossover Frequency Range:  80Hz, -12dB/Oct.